BIOINDUSTRY · PATHS

Replacing a chemical route with a biocatalytic one

A reagent that costs, or that nobody wants to handle any more. A protection and deprotection sequence. A separation that exists only because the chemistry created it. When an enzyme or a cell does the same work under milder conditions the numbers can change. The first thing to do is verify that, not announce it.

Talk to us about your step
WHEN IT MAKES SENSE

Three reasons a step gets replaced

A chemical step is not replaced because it is chemical. It is replaced when one of these three problems costs enough to justify the development.

The reagent is the problem

Cost, availability, safety or authorisations. If the biocatalytic step removes it, the saving is not only on the reagent: it is on everything around it, from storage to disposal.

Selectivity is the problem

The chemical route gives a mixture and the real cost is separating it. A regio- or stereoselective enzyme removes the problem upstream instead of solving it downstream.

Impact is the problem

Solvents, temperatures, waste. Milder conditions change the environmental profile of the process and, almost always, its energy consumption too.

How we get there

The path crosses several development areas. Not all of them are always needed: where you stop depends on where the process stops having problems.

1

Biocatalytic feasibility

Does a biocatalyst exist for this transformation, and does it work on your substrate rather than on the textbook one? Enzymes and whole-cell systems screened, first conversions run, a go or a no-go said early.

→ Bioconversion process development
2

The catalyst, when the commercial one is not enough

Producing the enzyme you need, or improving it where the enzyme itself is the limit: yield, selectivity, inhibition, operating window.

→ Heterologous expression and mutagenesis
3

Reuse and continuous operation

Recovering the biocatalyst and putting it back in cycle is almost always what makes the cost per kilogram of product affordable.

→ Enzyme immobilization
4

The downstream that changes

The new reaction produces a different stream: the separation has to be rebuilt, and it often ends up simpler than the one it replaces.

→ Downstream process development
5

Integration and scale-up

Mass balance on the whole process, robustness, cost of production and the package that lets it run in a plant.

→ Integration, scale-up and transfer

What we measure to decide

The substitution is decided on numbers, compared against the route you run today and not against an ideal case.

  • Conversion and selectivity — on your real substrate, with its impurities
  • Space-time yield — product per litre per hour, which is what a reactor is sized on
  • Biocatalyst productivity — kilograms of product per kilogram of enzyme or biomass
  • Cost per kilogram — against the current route, costed rather than asserted
  • Downstream simplification — how many steps disappear, which is often the largest saving
  • Impurity profile — because it is what decides the downstream
  • Robustness — how far substrate quality can vary before the reaction breaks
  • Reachable scale — how far the process goes, and with what plant constraints

What it takes to start

What you bring

  • The current reaction, with yields and conditions
  • The real substrate, not the purified standard
  • The product specification and the impurity profile allowed
  • The volumes and the scale you have to reach

What you take away

  • A reasoned go / no-go recommendation
  • If it is a go, the developed process with conditions and ranges
  • The dossier with data, conditions tested and results
  • The economic comparison against the route you replace

Start with the step that costs you most

Tell us which step of your synthesis you would like to remove, and why. We will tell you whether a biocatalytic route exists and what the first stage would look like.

Talk to us about your step

Tell us about your project

Write to us here: the division team will get back to you.